Yamaha DSP-A595a CONNECTIONS, AC OUTLET(S) (SWITCHED), GND terminal (for turntable use), CONNECTIONS WITH OTHER COMPONENTS

CONNECTIONS

Never plug in this unit and other components until all connections have been completed.

CONNECTIONS WITH OTHER COMPONENTS

Use RCA-type pin plug cables for connecting audio/video components with the exception described later.

When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the owner’s manual for each component to be connected to this unit.

*If you have YAMAHA components numbered as !, @, #, $, etc. on the rear panel, connections can be made easily by making sure to connect the output (or input) terminals of each component to the same-numbered terminals of this unit.

				AC OUTLET(S) (SWITCHED)
			Europe model .........................................................			2 OUTLETS
			U.K. model ................................................................			1 OUTLET
			Use these to connect the power cords from your components to
	DVD player,		this unit.
Turntable	LD player, etc.	Monitor TV	The power to the AC OUTLET(S) is controlled by this unit’s
			STANDBY/ON or the provided remote control’s POWER and
			STANDBY. These outlets will supply power to any connected
			component whenever this unit is turned on.
			The maximum power (total power consumption of components)
			that can be connected to the AC OUTLET(S) is 100 watts.
					(Europe model)

To AC outlet

CD player	Tuner	Tape deck,	TV/DBS tuner	VCR
		MD recorder, etc.		(Video cassette recorder)

GND terminal (for turntable use)

Connecting the ground (earth) wire of the turntable to the GND terminal will normally minimize hum, but in some cases, better

.

results may be obtained with the ground wire disconnected.

12