Amplifier

Remote control

Others

SYMPTOM

CAUSE

REMEDY

No sound from the effect speakers.

The sound effect setting is off.

Press EFFECT on the front panel or

 

 

EFCT ON/OFF on the remote control to

 

 

turn it on.

 

 

 

 

A Dolby Surround or DTS decoding

Use a different sound field program.

 

program is being used with material not

 

 

encoded with Dolby Surround or DTS.

 

 

 

 

No sound from the rear speakers.

The sound output level of the rear

Raise the sound output level of the rear

 

speakers is set to minimum.

speakers.

 

 

 

 

A monaural sound source is being

Select another sound field program

 

played in the DOLBY PRO LOGIC or

suitable for the monaural sound source.

 

DOLBY PRO LOGIC ENHANCED

 

 

program.

 

 

 

 

No sound from the center speaker.

The sound output level of the center

Raise the sound output level of the

 

speaker is set to minimum.

center speaker.

 

 

 

 

The function “CNTR” in the SET MENU

Select the LARGE or SMALL position.

 

is set to the NONE position.

 

 

 

 

 

Incorrect sound field program selection.

Select the appropriate program.

 

 

 

 

The input signals of the source encoded

Refer to the instructions for the source

 

with Dolby Digital or DTS do not have

being currently played.

 

center channel signals.

 

 

 

 

The sound field cannot be recorded.

It is not possible to record the sound

 

 

field on a tape deck or MD recorder

 

 

connected to the unit’s REC OUT

 

 

terminals.

 

 

 

 

The DVD/LD, TV or DBS source

The DVD/LD player, TV or DBS tuner is

Make additional connections between

cannot be recorded on a tape deck,

connected to the unit by only the digital

the analog terminals.

MD recorder or VCR connected to

terminals.

 

this unit.

 

 

The remote control does not work.

Direct sunlight or lighting (from an

Change the position of this unit.

 

inverter type of fluorescent lamp, etc.) is

 

 

striking the remote control sensor of this

 

 

unit.

 

 

 

 

 

The manufacturer’s code has not been

Set the code again.

 

set properly.

 

 

 

 

 

The proper manufacturer’s code for the

Try entering another code for the same

 

component to be controlled has not

manufacturer.

 

been set.

 

 

 

 

 

The component to be controlled has not

Set the SELECTOR DIAL to the proper

 

been selected.

position.

The sound is degraded when

This unit is in the standby mode.

Turn on the power of the unit.

listening with the headphones to a

 

 

CD player or tape deck that is

 

 

connected to this unit.

 

 

 

 

 

There is noise interference from

The unit is too close to the digital or

Move the unit further away from such

digital or high-frequency equipment

high-frequency equipment.

equipment.

or the unit.

 

 

 

 

 

English

43