Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage the unit and/or speakers.
English
Red: positive (+)
Black: negative
2
1
3
1Unscrew the knob.
2 Remove approx. 5 mm (1/4”) of insulation from each of the speaker wires and insert one bare wire into each terminal.
3 Tighten the knob to
secure the wire.
Red: positive (+)
Black: negative
3
2
1Press the tab.
2Remove approx. 5 mm (1/4”) of insulation from each of the speaker
1 wires and insert one bare wire into each terminal.
3Release the tab to secure the wire.
The speaker connections described on page 16 are fine for most applications. If for some reason, however, you wish to drive main, center and/or rear speakers with your existing amplifier, etc., the following terminals are available for connecting an external amplifier(s) to this unit.
17