This unit is equipped with additional
Connect the
Notes |
| |
• | When signals input to these terminals are selected, the digital |
|
| sound field processor cannot be used. |
|
• | The settings of “CNTR”, “REAR”, “MAIN” and “BASS” in the |
|
| SET MENU mode have no effect on the signals input to these |
|
| terminals. The setting of “M.LVL” is effective. (Refer to | (Europe model) |
| page 18 for details.) | |
•Adjustment of the output level of the center speakers, rear speakers and subwoofer is effective when the signals input to these terminals are selected as the input source. (Refer to page 31 for details.)
English
External decoder with
WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.
If this unit fails to turn on when the STANDBY/ON switch is pressed, the IMPEDANCE SELECTOR switch may not be fully set to either end. If so, set the switch to either end fully when this unit is in the standby mode.
IMPEDANCE SELECTOR
(Europe model)
Select the position whose requirements your speaker system meets.
(Upper position)
Main: If you use one pair of main speakers, the impedance of each speaker must be 4 Ω or higher.
If you use two pairs of main speakers, the impedance of each speaker must be 8 Ω or higher.
Center: The impedance of the speaker must be 6 Ω or higher.
Rear: The impedance of each speaker must be 6 Ω or higher.
(Lower position)
Main: If you use one pair of main speakers, the impedance of each speaker must be 8 Ω or higher.
If you use two pairs of main speakers, the impedance of each speaker must be 16 Ω or higher.
Center: The impedance of the speaker must be 8 Ω or higher.
Rear: The impedance of each speaker must be 8 Ω or higher.
15