SETUP CODES

Presetting the remote control

Perform the presetting procedure for each component you want to control with the remote control.

Note: If your component does not respond to any of the codes listed for the manufacturer, use the original remote control that was supplied with the component.

English

To control your components (MD recorder, DVD player, TV, etc.)

1.Turn on the component to be used.

2.Set the SELECTOR DIAL to the desired position for the component (TAPE/MD, DVD/LD, TV, etc.).

3.Press both VOLUME buttons ( ) for about four seconds at the same time so that the indicator flashes twice.

4.Use the numeric buttons to enter the four-digit manufacturer’s code for the component to be used. Make sure that the indicator flashes twice. If the indicator does not flash, repeat step 3 and re-enter the code.

5.Press POWER (or any other button) on the remote control to check if you have preset the code correctly. If the component cannot be controlled with the remote control, try entering another code for the same manufac- turer.

To use a second (and third) VCR

You can use the CBL/DBS and/or DVD MENU positions to control a second (and/or third) VCR if a CBL (or DBS) or DVD player is not being used.

If you are using the DVD MENU position for a second (or third) VCR, you must preset the code for an LD player to the DVD/LD position.

1.Turn on the VCR to be used.

2.Set the SELECTOR DIAL to the CBL/DBS or DVD MENU position.

3.Press both VOLUME buttons ( ) for about four seconds at the same time so that the indicator flashes twice.

4.Press MUTE.

5.Use the numeric buttons to enter the four-digit code for the second (or third) VCR. Make sure that the indicator flashes twice. If the indicator does not flash, repeat steps 3 and 4, and re-enter the code.

6.Press POWER (or any other button) on the remote control to check if you have preset the code correctly. If the VCR cannot be controlled with the remote control, try entering another code for the same manufac- turer.

Returning to the factory-set codes

To return all components to the factory- set codes, follow these steps.

1.Set the SELECTOR DIAL to a position other than the AMP/TUN or DSP position.

2.Press both VOLUME buttons ( ) for about four seconds at the same time so that the indicator flashes twice.

3.Enter code number “9987”.

4.Make sure that the indicator flashes twice.

To return each component to the factory- set code, follow these steps.

1.Set the SELECTOR DIAL to the position for the component to be returned to the factory-set code.

2.Press both VOLUME buttons ( ) for about four seconds at the same time so that the indicator flashes twice.

3.Enter code number “9999”.

4.Make sure that the indicator flashes twice.

The following codes are preset as the factory settings.

Factory-set codes

POSITION

Component

Code

 

 

 

TV

TV

0037

 

 

 

CBL/DBS

DBS tuner

2455

 

 

 

VCR

VCR

3072

 

 

 

DVD/LD

DVD player

4545 YAMAHA

 

 

 

CD

CD player

6187 YAMAHA

 

 

 

TAPE/MD

Tape deck

8524 YAMAHA

 

 

 

We recommend that you write all the code numbers you have preset on the “Quick Reference Card.”

41