Yamaha DVX-S100 Checking The Accessories, Installing Batteries In The Remote Control, DVR-S100

CHECKING THE ACCESSORIES

Check your package to make sure it contains the following items.

DVR-S100

Remote control				Batteries (x2)	AM loop antenna
				(AA, R06, UM-3)
POWER			POWER
TV	AV	SLEEP
TV MODE
	INPUT		TUNER
CH		VOL	MD
	MUTE		CD–R
SUBTITLE		AUDIO
REC			VCR
			VIDEO 2
			VIDEO 1	Indoor FM antenna
CODE SET		CD
SHIFT		DVD	AMP	(U.S.A., Canada and	(Europe, U.K. and
HALL	SETUP	ANGLE	MARKER
	JAZZ	ROCK	ENTERTAINMENT
1	2	3	4
SPORTS MONO MOVIE		MOVIE 1	MOVIE 2	General models)	Australia models)
5	PLAY MODE	REPEAT	A–B
	6	7	8
/DTS	SELECT MATRIX 6.1		STEREO
9	0	>–10	CANCEL
		GROUP	PAGE
TOP MENU MENU
LEVEL	SET MENU		MUTE
	PRESET	ABCDE
CH	ENTER	CH
	PRESET
TEST	B. BOOST		VOL
ON SCREEN RETURN

NX-SW100 (NX-S100S x4, NX-S100C, SW-S100)

Fasteners (4 sets)	Pads	Non-skid pads
for the center	(2 sets: 16 pieces)	(2 sets: 16 pieces)
speaker

Speaker cables	System connector
(for the rear speakers: 15m (x2),	cable (5m x 1)
for the front/center speaker:
5m (x3))

INTRODUCTION

Video pin cable

INSTALLING BATTERIES IN THE REMOTE CONTROL

Insert the batteries in the correct direction by aligning the

+and – marks on the batteries with the polarity markings (+ and –) inside the battery compartment.

2

1

3

1Press the part and slide off the battery compartment cover.

2Insert the two batteries (AA, R06, UM-3 type) with + and – oriented properly.

3Slide the cover back on so that it snaps into place.

■Notes on batteries

•Change all of the batteries if you notice a decrease in the operating range of the remote control.

•Do not use old batteries together with new ones.

•Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.

•If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

Preserving the manufacturer code

Replace batteries early before they become unusable. The manufacturer code set by the user will be preserved for about two minutes when batteries run out or when they are removed. Note that the manufacturer code setting may be lost if more than two minutes elapses. Also, if you press any button on the remote control accidentally while replacing batteries, the manufacturer code will be lost.

English

3