Yamaha Mixing Console 44 , Patching Omni Outs

44 Chapter 4—Connections and Setup
01V96—Owner’s Manual
3 Press [ENTER] to confirm the change.
Patching Omni Outs
By default, the output connectors are patched as follows:
•OMNI OUT connectors 1–4..............Aux Out 1–4
•ADAT OUT channels 1–8...................Bus Out 1–8
•Slot channels 1–8.................................Bus Out 1–8
•Slot channels 9–16...............................Bus Out 1–8
•2TR DIGITAL connectors..................Stereo Out L & R
Follow the steps below to view or change the patching.
1 Press the DISPLAY ACCESS [PATCH] button repeatedly until the following
page appears.
Signals that are currently assigned to the output connectors are shown in the parameter
boxes (1) underneath the connector numbers. The parameter indicators are explained
below:
•- ..............................................................No assignment
•BUS1–BUS8..........................................Bus Out 1–8 signals
•AUX1–AUX8........................................Aux Out 1–8 Signals
•ST L/R....................................................Stereo Out signals
•INS CH1–INS CH32...........................Input Channels 1–32 Insert Outs
•INS BUS1–INS BUS8..........................Bus Out 1–8 Insert Outs
•INS AUX1–INS AUX8.........................Aux Out 1–8 Insert Outs
•INS ST-L/ST-R......................................Stereo Out Insert Outs
•CAS BUS1–BUS8.................................Bus Out 1–8 Cascade Outs
•CAS AUX1–AUX8................................Aux Out 1–8 Cascade Outs
•CAS ST-L/ST-R.....................................Stereo Out Cascade Outs
•CASSOLOL/CASSOLOR....................Solo Channel Cascade Outs
Tip: To restore the default patching, recall Input Patch memory #00 (see page 174).
Tip:
•The STEREO OUT connectors always output the Stereo Bus signals.
•The MONITOR OUT connectors output monitor signals or the 2TR IN signals, depending
on the Monitor Source selector setting.
1