Yamaha Mixing Console 7 Input Channels

Input Channels 77
01V96—Owner’s Manual
Input Channels
7
7 Input Channels
This chapter describes how to adjust the 01V96’s Input Channel parameters.
About Input Channels
The input Channel section enables you to adjust the level and tone of the signals input to
the 01V96 (and the signals output from the internal Effects processors 1–4), and route the
signals to Buses 1–8, the Stereo Bus, and Aux Sends 1–8. There are two types of Input Chan-
nels, each featuring slightly different functions: monaural Input Channels 1–32 and stereo
ST IN Channels 1–4.
Input Channels 1–32
Each of these monaural Input Channels features a phase effect, gate, compressor, attenua-
tor, and EQ for signal processing. The following diagram illustrates the Input Channel 1–32
signal flow.
Input Channels 1–32 feature the following parameters:
• (Phase)
This section switches the phase of input signals.
•GATE
This dynamics processor can be used as a gate or for ducking.
•COMP (Compressor)
This dynamics processor can be used as compressor, expander or limiter. The compressor
can be pre-EQ, pre-fader, or post-fader.
•ATT (Attenuator)
This section enables you to attenuate or amplify the level of signals that will be input to the
EQ. The attenuator enables you to prevent post-EQ signals from clipping and to correct sig-
nal levels that are too low.
•4 BAND EQ (4-band equalizer)
This parametric EQ features four bands (high, high-mid, low-mid, and low).
•INPUT DELAY (Input delay)
This section enables you to delay input signals. You can use this delay to fine-tune the timing
between channels, or as a delay effect with feedback.
STEREO L
STEREO R
SOLO L
SOLO R
AUX 1
AUX 8
BUS1
BUS2
BUS3
BUS4
BUS5
BUS6
BUS7
BUS8
INPUT 1(...32)
ATT 4BAND
EQ
INPUT
DELAY
METER
LFE
SOLO
PRE/POST ON
DIRECT OUT 1(...32)
Keyin
12ch Group(1-12,13-24....)
AUX 1-8
INSERT
PAN
PAN
GATE
AUX
COMP
METER
(Gain Reduction)
INSERT
ON LEVEL
Keyin
Self or Stereo Link
METER
(Out Meter)
(Gain Reduction)
(Out Meter)
METER
METER
METER
INPUT PATCH