Optimizing the speaker setting for your listening room
This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid troublesome
| Using AUTO SETUP | 2 Connect the supplied optimizer microphone |
| to the OPTIMIZER MIC jack on the front |
Notes | panel. |
| |
| OPTIMIZER MIC |
• Be advised that it is normal for loud test tones to be output |
|
during the “AUTO SETUP” procedure. | DISPLAY |
• To achieve the best results, make sure the room is as quiet as | YTUNING AUTO/MAN'L |
| |
possible while the “AUTO SETUP” procedure is in progress. If |
|
there is too much ambient noise, the results may not be | VIDEO AUX |
| VIDEO L AUDIO RPORTABLE |
satisfactory. | AUDIO SELECT |
|
y
You can run “AUTO SETUP” using the system menu that appears in the OSD or in the front panel display. This manual uses the OSD illustrations to explain the “AUTO SETUP” procedure.
1Make sure of the following check points before starting the AUTO SETUP operations.
❏Speakers are connected appropriately.
❏Headphones are disconnected from this unit.
❏This unit and the video monitor are turned on.
❏The connected subwoofer is turned on and the volume level is set to about half way (or slightly less).
❏The crossover frequency controls of the connected subwoofer is set to the maximum.
❏FRONT A speakers are selected as the front speaker system (see page 30).
❏The room is sufficiently quiet.
Optimizer microphone
The following display appears in the OSD.
AUTO:MENU
.SETUP;;;;;;;AUTO START
Automatic
Processing of all item
[p]/[p]:Up/Down [p]/[[]:Select
3Place the optimizer microphone at your normal listening position on a flat level surface with the microphone heading upward.
Optimizer microphone
y
It is recommended that you use a tripod (etc.) to affix the optimizer microphone at the same height as your ears would be when you are seated in your listening position. You can use the attached screw of a tripod (etc.) to fix the optimizer microphone to the tripod (etc.).