Troubleshooting

After AUTO SETUP

Warning message

Cause

Remedy

See

page

 

 

 

 

 

 

 

W-1:OUT OF PHASE

Speaker polarity is not correct. This

 

message may appear depending on the

 

speakers even when the speakers are

 

connected correctly.

Check the speaker connections for proper polarity (+ or –).

12

W-2:OVER 24m (80ft)

The distance between the nearest speaker

Bring the speaker closer to the listening

—

 

and the furthest speaker is out of adjustable

position.

 

range.

 

 

 

 

 

 

W-3:LEVEL ERROR

The difference of volume level among

If “SWFR:TOO LOUD” or “SWFR:TOO

 

 

speakers is excessive. (No level correction

LOW” appears, adjust the output volume of

22

 

is made.)

the subwoofer.

 

 

 

 

 

 

 

Readjust the speaker installation so that all

 

 

 

speakers are set in locations with similar

—

 

 

conditions.

 

 

 

 

 

 

 

Check the speaker connections.

12

 

 

 

 

 

 

Use speakers of similar quality.

—

 

 

 

 

Notes

•If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.

•If a warning message “W-1” appears, corrections are made, but they may not be optimal.

•If a warning message “W-2” or “W-3” appears, no corrections are made.

•If an error message “E-6” occurs repeatedly, please contact a qualified Yamaha service center.

■iPod

Note

In case of a transmission error without a status message appearing in the front panel and in the OSD, check the connection to your iPod (see page 18).

Status message

Cause

Remedy

See

page

 

 

 

Loading...

This unit is in the middle of recognizing

 

 

 

the connection with your iPod.

 

 

 

 

 

 

 

This unit is in the middle of acquiring

 

 

 

song lists from your iPod.

 

 

 

 

 

 

Connect error

There is a problem with the signal path

Turn off this unit and reconnect the Yamaha iPod

18

 

from your iPod to this unit.

universal dock to the DOCK terminal of this unit.

 

 

 

 

 

 

 

Try resetting your iPod.

—

 

 

 

 

Unknown iPod

The iPod being used is not supported by

Only iPod (Click and Wheel), iPod nano, and iPod

—

 

this unit.

mini are supported.

 

 

 

 

 

iPod connected

Your iPod is properly stationed in a

 

 

 

Yamaha iPod universal dock (YDS-10,

 

 

 

sold separately) connected to the DOCK

 

 

 

terminal of this unit, and the connection

 

 

 

between your iPod and this unit is

 

 

 

complete.

 

 

 

 

 

 

Disconnected

Your iPod was removed from a Yamaha

Station your iPod back in a Yamaha iPod universal

18

 

iPod universal dock (YDS-10, sold

dock (YDS-10, sold separately) connected to the

 

 

separately) connected to the DOCK

DOCK terminal of this unit.

 

 

terminal of this unit.

 

 

 

 

 

 

Unable to play

This unit cannot play back the songs

Check that the songs currently stored on your iPod

—

 

currently stored on your iPod.

are playable.

 

 

 

 

 

 

 

Store some other playable music files on your iPod.

—

 

 

 

 

70 En