4Set the operation mode selector (K) to AMP and then press D l/ hto select “AUTO”.

Choices: AUTO, RELOAD, UNDO, DEFAULT

Select “AUTO” to automatically run the entire “AUTO SETUP” procedure.

Select “RELOAD” to reload the last “AUTO SETUP” settings and override the previous settings.

Select “UNDO” to undo the last “AUTO SETUP” settings and restore the previous settings.

Select “DEFAULT” to reset the “AUTO SETUP” parameters to the initial factory settings.

Note

“RELOAD” or “UNDO” is available only when you have previously run “AUTO SETUP” and confirmed the results.

Optimizing the speaker setting for your listening room

The display changes as follows.

AUTO:MENU

SETUP;;;;;;;AUTO

.START

Automatic

Processing of all item

[p]/[p]:Up/Down [ENTER]:Start

AUTO:CHECK

INITIALIZING

.WIRING/LEVEL DISTANCE SIZE



WAITING;;;

;;;;;;;;;;

[]:Exit

PREPARATION

5Press D nto select “START” and then press

D ENTER to start the setup procedure.

This unit starts the auto setup procedure. Loud test tones are output from each speaker during the auto setup procedure. Once all items are set, the “AUTO:RESULT” display appears in the OSD.

Notes

During the auto setup procedure, do not perform any operation on this unit.

We recommend getting out of the room while this unit is in the auto setup procedure. It takes approximately 3 minutes for this unit to complete the auto setup procedure.

This unit performs the following checks:

Speaker wiring/volume level WIRING/LEVEL

Checks which speakers are connected and the polarity of each speaker. Also checks and adjusts the volume level of each speaker.

Speaker distance DISTANCE

Checks the distance of each speaker from the listening position and adjusts the timing of each channel.

Speaker size SIZE

Checks the frequency response of each speaker and sets the appropriate low-frequency crossover for each channel.

AUTO:RESULT

NO WARNING RESULT

SP : 3/2/0.1

DIST: 3.2/3.5m

LVL : -2/+2dB

. >SET CANCEL []/[]:Up/Down [ENTER]:Enter

The results displayed under “RESULT” are as follows.

Number of speakers SP

Displays the number of speakers connected to this unit in the following order:

Front/Back/Subwoofer

Speaker distance DIST

Displays the speaker distance from the listening position in the following order:

Closest speaker distance/Farthest speaker distance

Speaker level LVL

Displays the speaker output level in the following order: Lowest speaker output level/Highest speaker output level

Notes

If “E-6:INTERNAL ERROR” appears during the testing procedure, restart from step 4.

If you selected “RELOAD” in step 4, no test tones are output.

If an error occurs during the “AUTO:CHECK” procedure, the setup procedure is canceled and an error screen appears. For details, see “If an error screen appears” on page 25.

When this unit detects potential problems during the “AUTO SETUP” procedure, “WARNING” and the number of warning messages appears in the above of “RESULT” (see page 25).

English

23 En