88
Fmod (Frequency modulation depth)
Range: 0 … 127
Controls: [CS5], [-1] [+1], Dial
Sets the maximum depth of filter cutoff frequency modulation (wah-wah
type effects) applied via keyboard aftertouch.
A setting of “0” allows no frequency modulation, while a setting of 127
results in maximum frequency modulation.
When setting up the LFO (low-frequency oscillator) to apply cutoff modula-
tion, this parameter must be set to a value other than “0” if cutoff modulation
is to be applied via keyboard aftertouch. Also, the filter “CTRL” parameter
(page 68) must be set to “LFO” in order to vary the cutoff frequency continu-
ously.
EGBs (EG bias depth)
Range: -127 … +127
Controls: [CS6], [-1] [+1], Dial
Sets the depth and “direction” of EG bias produced by aftertouch response.
EG bias increases or decreases the amplitude envelope generator levels, simu-
lating the dynamic variations that can be produced on an acoustic instrument
more accurately than simple volume control.
A setting of “0” produces no change in EG levels. Plus (“+”) settings
produce an increase in level when aftertouch is applied, and minus (“-”) set-
tings produce a decrease in level when aftertouch is applied. The greater the
value, the greater the change in level.
Coff (Cutoff frequency depth)
Range: -127 … +127
Controls: [CS7], [-1] [+1], Dial
Sets the maximum depth of filter cutoff frequency variation applied via
keyboard aftertouch.
Plus “+” settings produce higher cutoff frequencies in response to aftertouch
— i.e. the greater the aftertouch pressure, the higher the cutoff frequency. The
maximum setting of “+127” produces the maximum cutoff variation. Minus “-”
settings produce the opposite effect: lower cutoff in response to greater
aftertouch pressure. A setting of “+0” results in no cutoff variation. The filter
“CTRL” parameter (page 68) must be set to “LFO” in order to vary the cutoff
frequency continuously.
PtBs (Pitch bias depth)Range: -12 … +12
Controls: [CS8], [-1] [+1], Dial
Sets the maximum pitch variation range achievable via after-touch control.
Each increment represents a semitone. A setting of “0” produces no pitch
variation. A setting of “+12” allows a maximum pitch variation of one octave
up, while a setting of “-12” allows a maximum pitch variation of one octave
down corresponding to aftertouch key pressure.
VOICE EDIT MODE / 6:Controller