PERIODIC MAINTENANCE AND MINOR REPAIR
1.Axle nut
2.Washer
EAU41691
To install the front wheel
1.Lift the wheel up between the fork legs.
2.Insert the wheel axle from the
NOTE:
Make sure that the slot in the brake shoe plate fits over the retainer on the fork leg.
Tightening torque:
Axle nut:
35Nm (3.5 m·kgf, 25 ft·lbf)
5.Adjust the brake lever free play. (See page
6.While applying the front brake, push down hard on the handlebar several times to check for proper fork operation.
3.Lift the front wheel off the ground according to the procedure on
page
64. Remove the axle nut and washer.
5.Pull the wheel axle out, and then remove the wheel.
2
1
1. Slot
2. Retainer
3. Lower the front wheel so that it is on the ground.
4. Install the washer and axle nut, and then tighten the axle nut to the specified torque.
1. Wheel axle
