PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
1.Engine oil filler cap
2.Dipstick
3.Maximum level mark
4.Minimum level mark
NOTE:
6The engine oil should be between the minimum and maximum level marks.
4.If the engine oil is at or below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level.
5.Insert the dipstick into the oil filler hole, and then tighten the oil filler cap.
To change the engine oil
1. Start the engine, warm it up for several minutes, and then turn it off.
2. Place an oil pan under the engine to collect the used oil.
3. Remove the engine oil filler cap and drain bolt to drain the oil from the crankcase.
1
1.Engine oil drain bolt
4.Install the engine oil drain bolt, and then tighten it to the specified torque.
Tightening torque: Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
5.Add the specified amount of the recommended engine oil, and then install and tighten the engine oil fill- er cap.
Recommended engine oil: See page
Oil change quantity:
0.80L (0.85 US qt) (0.70 Imp.qt)
ECA11620
CAUTION:
●In order to prevent clutch slip- page (since the engine oil also lubricates the clutch), do not mix any chemical additives. Do not use oils with a diesel speci- fication of “CD” or oils of a high- er quality than specified. In addition, do not use oils labeled “ENERGY CONSERVING II” or higher.
●Make sure that no foreign mate- rial enters the crankcase.
6.Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, im- mediately turn the engine off and check for the cause.
