Setup Menu
Progressive
This feature is only valid if you have connected this unit to a progressive scan TV through the component video jacks (see “Component video jacks <B>” on page 7).
1In “VIDEO SETUP PAGE”, press 3 /4 to highlight [PROGRESSIVE], and then press 2.
ON
Select this to enable the progressive scan function.
OFF
Select this to disable the progressive scan function.
2Press 3 /4 to select a setting, and then press ENTER/OK to confirm your selection.
Notes on activating progressive scan:
–Ensure that your TV is equipped with progressive scan.
–Connect using a component video cable.
–Ensure that “COMPONENT is set to “YUV” (see “Switching the YUV/RGB” on page 27).
–When the progressive scan is active, the VIDEO (CVBS) jack and the AV (SCART) terminal do not output video signals.
–If no picture is displayed, wait for 15 seconds for this unit to activate automatic recovery, or deactivate progressive scan manually as follows:
1Press / (OPEN/CLOSE) on the front panel to open the disc tray.
2Press 1.
3Press ANGLE.
CONSUMERS SHOULD NOTE THAT NOT ALL HIGH DEFINITION TELEVISION SETS ARE FULLY COMPATIBLE WITH THIS PRODUCT AND MAY CAUSE ARTIFACTS TO BE DISPLAYED IN THE PICTURE. IN CASE OF 525 OR 625 PROGRESSIVE SCAN PICTURE PROBLEMS, IT IS RECOMMENDED THAT THE USER SWITCH THE CONNECTION TO THE “STANDARD DEFINITION” OUTPUT. IF THERE ARE QUESTIONS REGARDING OUR VIDEO MONITOR COMPATIBILITY WITH THIS MODEL 525P AND 625P DVD PLAYER, PLEASE CONTACT OUR CUSTOMER SERVICE CENTER.
This unit is compatible with the complete line of YAMAHA products, including the projectors
Picture settings
This unit comes with three predefined sets of picture color settings and one personal setting that you can define yourself.
1In “VIDEO SETUP PAGE”, press 3 /4 to highlight [PICTURE SETTING], and then press 2.
STANDARD
Select this for the standard picture setting.
BRIGHT
Select this to make the TV picture brighter.
SOFT
Select this to make the TV picture softer.
PERSONAL
Select this to personalize your picture color by adjusting the brightness, contrast, tint and color (saturation).
2Press 3 /4 to select a setting, and then press ENTER/OK to confirm your selection.
TIPS: To return to the previous menu, press 1. To exit from the menu, press SETUP.
26En
