Adjusting the system parameters
4Press 
/ 
to switch between “F.PANEL: ON” and “F.PANEL: OFF”.
ENTER
F.PANEL: | ON |
|
|
Setting the FACTORY PRESET
You can reset all of the parameters of this unit to the factory presets. This procedure completely resets ALL the parameters in SET MENU.
Note
After performing the following procedure you must run AUTO SETUP again to match your surround sound environment.
1Repeat steps 1 to 3 in “Using the system parameters” on page 88.
2Set the operation mode selector to YSP.
TV/AV
YSP
F.PANEL: | OFF |
|
|
•Select F.PANEL: ON to enable the front panel keys.
•Select F.PANEL: OFF to disable the front panel keys. “P.INPUT” is automatically set to “ON”.
5Press STANDBY/ON on the remote control to set this unit to the standby mode.
STANDBY/ON
3Press 
/ 
so that “FACTORY PRESET” is displayed in the front panel display.
ENTER
FACTORY | PRESET |
The new setting will be activated when you turn on the power of this unit next time.
4 Press ENTER.
ENTER
