TC | Technicoat Condenser Coil & Coil Guard |
|
|
TD | Technicoat Condenser Coil & Dirty Filter Switch |
|
|
TG | Technicoat Condenser Coil, Coil Guard, & Dirty Filter Switch |
|
|
TJ | Technicoat Evaporator Coil |
|
|
TL | Technicoat Evaporator Coil & Coil Guard |
|
|
TM | Technicoat Evaporator Coil & Dirty Filter Switch |
|
|
TQ | Technicoat Evaporator Coil, Coil Guard, & Dirty Filter Switch |
|
|
TS | Technicoat Evaporator & Condenser Coils |
|
|
TU | Technicoat Evaporator & Condenser Coils & Coil Guard |
|
|
TV | Technicoat Evaporator & Condenser Coils & Dirty Filter Switch |
|
|
TY | Technicoat Evaporator & Condenser Coils, Coil Guard, & Dirty Filter Switch |
|
|
INSTALLATION
INSTALLATION SAFETY INFORMATION
Read these instructions before continuing this appliance installation. This is an outdoor combination heating and cool- ing unit. The installer must assure that these instructions are made available to the consumer and with instructions to retain them for future reference.
1.Refer to the furnace rating plate for the approved type of gas for this furnace.
2.Install this furnace only in a location and position as specified on Page 11 of these instructions.
3.Never test for gas leaks with an open flame. Use com- mercially available soap solution made specifically for the detection of leaks when checking all connections, as specified on Pages 8, 24, 25 and 40 of these instruc- tions.
4.Always install furnace to operate within the furnace's intended
5.This equipment is not to be used for temporary heating of buildings or structures under construction.
FIRE OR EXPLOSION HAZARD
Failure to follow the safety warning exactly could result in serious injury, death or property damage.
Never test for gas leaks with an open flame. use a commercially available soap solution made specifi- cally for the detection of leaks to check all connec- tions. A fire or explosion may result causing property damage, personal injury or loss of life.
PRECEDING INSTALLATION
1.Remove the two screws holding the brackets in the front, rear and compressor side
Bracket | Turn down | |
Screws | ||
|
FIGURE 1 - UNIT SHIPPING BRACKET
8 | Unitary Products Group |