Media Handling
Laminating Station
2.Grasp the cassette and pull it straight toward you, clear of the printer.
Caution • If you feel resistance when removing the cassette, the laminate has likely run out, leaving one end attached to the core and the other end under the cutter. Keep tugging on cassette, which will come free with a short tail of laminate.
Caution • Remove the transfer guide to be sure there are no scraps of laminate remaining.
3.Open the cassette, like a clam shell, by separating its two halves. Grasp the two halves firmly with the fingers, then pull. Do NOT use tools to pry it apart.
Loading the cassettes1.Discard the spent core. Hold the open cassette with its cavities toward you, white idler wheel to the top.
Caution • You need partial width laminate for the LOWER cassette if there is a mag stripe or signature stripe on the card
2.Place a roll of laminate in the cassette so that it feeds from the bottom of the roll, UP and OUT to the front. Pull out an inch or two of laminate.
Caution • If the lower cassette is intended for partial width laminate, it will have an edge guide to keep the laminate on track. Make sure it is in the correct position for the partial width laminate you are using.
P640i Card Printer User Guide | 17 |