Media Handling

Laminating Station

Installing the cassettes

Cassette

pocket

Cassette

latch

3.Close the cassette, then pull out a little more laminate. If it suddenly stops, resisting further pulling, a spring detent on the cassette, photo below, has snagged a notch on the end of the core. This means that the core was installed the wrong way round. If you follow the installation diagram on the inside of the cassette this won’t happen!

4.With the white roller up and pointing to your left, rotate the core counter clockwise to reel in the laminate. Stop when the end of the laminate is even with the lips of the cassette - no overhang, but make sure it is not clear of the white roller (otherwise it won’t feed).

Caution • If the end of the laminate is crinkled or uneven, cut it as square as you can with scissors, then reel it in.

Important • Check for overhang any time the cassette latch is opened, or the cassette isremoved.

1.Make sure the laminate is even with the lips of the cas- sette.

2.Insert the cassette into its black molded pocket, then close the cassette latch (clockwise for the UPER, counterclock- wise for the LOWER).

3.Close the main cover. If there was a laminate error before you replaced the cassette, laminate will automatically feed from the just-loaded cassette, followed by a cutting action to free a “patch” of laminate onto the transfer roller. If laminate does not feed automatically, press the LAMI- NATE button.

18

P640i Card Printer User Guide

980541-001 Rev. A