Media Handling
Laminating Station
Clearing the Laminate ChannelsIf your scissor cuts were neat enough to pass for machine-made cuts, continue printing cards in the usual way. If not, don’t waste a print cycle. Instead, remove the hand-cut patch(es) from the transfer roller(s) as follows.
Important • Clearing procedures for the upper and lower channels are similar. The upper channel is shown here.
Removal of the Transfer Guide gives access to the transfer roller.
1.Pull back the retaining spring, at the same time pulling the Transfer Guide straight out toward you.
2.Remove and discard the laminate patch on the transfer roller. Never re-use!
3.Re-install the Transfer Guide with its top edge above the laminate cutter guide. It’s easier if you pull back the retaining spring while re-inserting the guide, then release the spring as you push the guide into position (it will click into place, with its far leg against the back plate of the laminator). Press the LAMINATE button to load the transfer roller(s).
980541-001 Rev. A | P640i Card Printer User Guide | 19 |
