Charging the Battery
Refer to Figure 3 (your battery charger may look slightly different than the ones illustrated).
If you are using a 120 VAC battery charger:
1.With the battery installed in the printer, insert the connector of the battery charger into the receptacle on the side of the printer.
2.Plug the battery charger into an appropriate 120 VAC electrical outlet.
3.The battery charging LED will briefly flash and then stay on. When the battery is fully charged (approximately one hour for the standard battery; two hours for the extended life battery), the light will go off.
4.You may either remove the battery charger from the printer or leave it connected for a continuous maintenance charge.
If you are using a universal battery charger:
1.With the battery installed in the printer, insert the connector of the battery charger into the receptacle on the side of the printer.
2.Make sure the supplied power cord is inserted in the battery charger.
3.Plug the other end of the cord into an appropriate AC electrical outlet.
| Power |
120 VAC | Cord Plug |
Charger | Varies by |
| Country |
Universal
Charger
Figure 3
4