NOTE: The plastic media core can be obtained from an
authorized Zebra supplies reseller.
7.Release the media hangers so the plastic media core locks into the correct position.
8.Place the fanfold media in the fanfold media tray.
9.Swing up the media access door. Thread the fanfold media through the slot beneath the notch on the media access door (refer to Figure 12).
10.Swing open the media access door. Continue to insert the media into the printer and under the plastic media core until it appears beneath the printhead. Make sure the media is threaded under both media guides.
If you’re using direct thermal media, continue on with step 11. However, if you’re using thermal transfer media, you must also install a ribbon cartridge. Proceed to “Loading the Ribbon” in this chapter.
11.Swing up the media access door, ensuring that the media extends over the tear bar (refer to Figure 13).
12.Lift to hook the top of the media access door over the top cover.
13.Push in the bottom of the media access door to close.
14.Turn on the printer or press the Feed button if the printer is already on.
14