Calibration

Auto Calibration

NOTE: The printer will not auto calibrate when you are using

pre-printed labels or pre-printed label backing. If you are using this type of media, see “Manual Calibration.”

By default, this printer automatically sets the sensor levels for, and determines the length of, the label you are using. To auto calibrate:

1.Load the media according to the instructions in “Loading the Media” in Getting Ready to Print.

2.Turn on the printer or press the Feed button if the printer is already on.

3.Some blank labels will feed, completing auto calibration.

4.If the Error LED begins flashing, refer to “Manual Calibration.”

Hints:

•Auto calibration only works when you are using non-continuous media (a gap, notch, or black mark separates each label).

•When auto calibration is selected, it occurs when the printer is turned on (if the printhead has been opened), whenever an error is cleared, or if the battery (or other power source) has been removed.

27