Zebra Technologies PA400, PT400 Figure, Figure, Pivot the top cover to reveal the printhead, 3.Pivot the top cover to reveal the printhead, Fanfold Media (optional vibration mount required)

Fanfold Media (optional vibration mount required)

NOTE: If ribbon is loaded (PT400 only), remove the ribbon

cartridge before loading the media.

1.Raise the media access door by lifting at the notch until it unhooks from the top cover (refer to Figure 4).

2.Swing the media access door open to expose the media compartment (refer to Figure 5).

3.Pivot the top cover to reveal the printhead.

4.Lift the printhead until you feel it “lock” into place. Be careful not to force the printhead past this position!

WARNING: NEVER touch the thermal print elements on the underside of the printhead. Under certain conditions, they can be very hot! Also, dirt or moisture from your hands can damage the printhead!

5.Separate and hold open the media hangers (refer to Figure 11).6.Place the plastic media core (refer to Figure 11) onto the media hangers.

Media

Guides

Media

Hangers

Plastic

Media

Core

Figure 11

13