Zenoah EXZ2401S manual Operation EX2-BC only, English Optional blade usage, EX2-BC OP8

EX2-BC OP8

English (Optional blade usage)

8. Operation (EX2-BC only)

■OPERATION

1.Check the bolt to fasten the blade and be sure the bolt has no fault, and no abrasion.

2.Be sure that the blade and the holder have been fastened according to instruction and the blade turns smoothly without abnormal noise. (OPT10)

WARNING

•The rotating parts fastened incorrectly may cause serious accident to the operator.

•Make sure that the blade is not bent, warped, cracked, broken or damaged.

•If you find any error to the blade, discard it and change new one which is certified by RedMax.

■By using the shoulder strap, hang the unit on your right side. Adjust the strap length so that the cutting head may become parallel to the ground. (OP8)

WARNING

Make sure to use shoulder strap and debris guard. If not, it is very dangerous when you slip or lose your balance.

WARNING

■CONTROLLING BLADE THRUST

•Blade thrust can cause serious personal injury. Carefully study this section. It is important that you understand what causes blade thrust, how you can reduce the chance of blade thrust and how you can remain in control of the unit if blade thrust does occur.

1. What causes blade thrust:

•Blade thrust can occur when the moving blade contacts an object that it cannot cut. This contact causes the blade to stop for an instant and then suddenly move or ”bounce” away from the object that was hit. The operator can lose control of the unit and the blade can cause serious personal injury to the operator or any person nearby if the blade contacts any part of the body.

48