Zenoah EXZ2401S manual Maintenance EX-HE only, EX-PS MA8 MA9 MA1

EX-PS

MA8

EX-PS

MA9

MA1

English

9. Maintenance (EX-PS only)

Make sure every cutter has the same length and edge angles as illustrated. (MA8)

(4)Cutter length

(5)Filing angle

(6)Side plate angle

(7)Top plate cutting angle

■GEAR CASE

The reduction gears are lubricated by multipurpose, lithium-based grease in the gearcase.

Supply new grease every 25 hours of use or more often depending on the job condition.

When adding lubricant, use a grease gun to insert lubricant into the three grease nipples located on the gear case. (MA9)

(1) Grease fitting

9. Maintenance (EX-HE only)

■GEAR CASE

•The reduction gears are lubricated by multipurpose, lithium-based grease in the gear case. At every 20 hours of use, supply the gear case with new grease.

•Remove the cutter holders before installing new grease to arrange for old grease to exit.

NOTE

•When removing and installing the cutter holder(a), use care not to allow any dirt and dust entering in to the gear case.

84