31
ZOOM B9.1ut
Using the Expression Peda l

Assigning control

targets to the

expression pedal

This section explains how to assign a control
target to the expression pedal. Four control
targets each can be assigned for the vertical
direction and the horizontal dir ection. Module
on/off switching is available for the vertical
direction only.
In manual mode or play mode,

1.

select the patch.
Press the [PEDAL] key.

2.

The display changes as follows.
7=$4P_
46+!*OVY\Z
Control target indication
(PV1 – PV4, PH1 – PH4)
Control target
parameter name
Module name Effect type name
HINT
The expression pedal setting is in cluded in the
TOTAL/FUNCTION module for the resp ective
patch. The above display can a lso be called up
by pressing the [TOTAL/FUNCTION] effe ct
module key and turning the [ TYPE] knob.
To assign a control target for t he

3.

vertical directio n, turn the [TYPE]
knob to select one of the fou r
vertical directio n control targets
(PV1 to PV4).
The operation steps for setting the vertical
direction control targets PV1 to PV4 are the same.
[TYPE] knob
Turn parameter knob 1 to selec t

4.

the parameter that is to b e
controlled.
Parameter knob 1
As you turn parameter knob 1, the effect
parameter, effect type, and effect module
settings change.
HINT
• For information on whi ch parameters can be
selected as control targets, see "Eff ect Types
and Parameters" on pages 64 – 79.
• When "Volume" is selected as co ntrol target,
the expression pedal functio ns as a volume
pedal.
• When "NOT Assign" is displaye d, no
parameter is assigned to the current co ntrol
target. By setting all four control ta rgets to
"NOT Assign", the vertical direction actio n of
the expression pedal can be defeate d.
NOTE
If you select "NOT Assign", steps 5 and 6 cannot
be carried out.
To set the adjustment range for t he

5.

parameter to be contro lled, use
parameter knob 2 (minimu m value)
and parameter knob 3 (max imum
value).
The display changes as follows.
7=$4P_l
wTPU$
7=$4P_l
p4(?$
Parameter knob 2
Parameter knob 3
Minimum value
Maximum value
■ When parameter knob 2 is operated
■ When parameter knob 3 is operated