47
ZOOM B9.1ut
MIDI Usage Examples
To enable the B9.1ut to receive
2.
control change messa ges, turn the
[TYPE] knob to bring u p the "MIDI
CTRL Rx" (receive control ch ange)
parameter, and turn param eter
knob 1 to select the "ON" set ting.
40+0 *;939_$65lParameter knob 1
To enable the B9.1ut to send
3.
control change messa ges, turn the
[TYPE] knob to bring u p the "MIDI
CTRL Tx" (send control change)
parameter, and turn param eter
knob 1 to select the "ON" set ting.
40+0 *;93;_$65lParameter knob 1
When the setting is co mplete,
4.
press the [EXIT] key to ca ncel the
SYSTEM menu.
If a setting was changed, the indication
"Store...?" appears on the display, to allow you
to store the changes.
If no setting was changed, the unit returns to t he
previous mode.
:[VYL&
@B:;69,D5B,?0;D
Press the [STORE/SWAP] key to
5.
save the changes.
The setting is accepted, and the unit retur ns to
manual mode or play mode. By pressing the
[EXIT] key, you can abort the changes and
return to play mode without saving.
■ Assigning control change numbers
You can assign control change numbers to
the expression pedal and keys of the B9.1ut as
follows.
NOTE
Before carrying out the following step s, verify
that the send/receive MIDI chann el setting of
the B9.1ut is as required (→ p. 42), and that
send/receive of control change messages is
enabled (→ p. 46).
In manual mode or play mode,
1.
press the [SYSTEM] key.
70*2<7:LS (*;0=,
Turn the [TYPE] knob to bri ng up
2.
the display for assign ing a control
change number.
Operations to which a control change number
can be assigned are listed in the table on the
next page.
For example, to assign the control change
number 11 (cc#11) to the vertical direction of the
built-in expression pedal, the following display
is used.
40+0JJ 7,+(3=$[TYPE] knob
HINT
The control change number assignm ent always
applies both for sending and receiving.
Turn parameter knob 1 to speci fy a
3.
control change numbe r.
40+0JJ 7,+(3=$lParameter knob 1