53
ZOOM B9.1ut
Other Functions
HINT
• The available range set ting depends on the
parameter.
• It is also possible to set "m in" to a higher
value than "MAX". In that ca se, the control
change direction will be reversed.
When the control tar get and
5.
parameter range have be en set,
turn the [TYPE] kn ob clockwise to
bring up the following di splay.
This display lets you select the control waveform
and cycle.
(994$9H[L
>H]L$<WZH^[TYPE] knob
The ARRM function has a total of five
parameters. To set parameters 4 and 5, turn
the [TYPE] knob to bring up the above display
and then use parameter knobs 1 and 2 to make
the setting. To return to the setting condition
for parameters 1 – 3, turn the [TYPE] knob
counterclockwise to return to the previous
display. If the ARRM control target is set to
"Not Assign", this display does not appear.
Turn parameter knob 1 to selec t
6.
the control waveform ty pe.
The display changes as follows.
(994$9H[L
>H]L$;YPHUNSLControl waveform type
Parameter knob 1
Available waveforms are shown below.
Rising sawtooth
(Up Saw)
Rising fin
(Up Curve)
Falling sawtooth
(Down Saw)
Falling fin
(Down Curve)
2
1
3
4
Triangle
(Triangle)
Square triangle
(Square Tri)
Sine wave
(Sine)
Square wave
(Square)
6
5
7
8
Turn parameter knob 2 to selec t
7.
the control waveform cycle.
The display changes as follows.
(994$9H[L
:`UJ$_Parameter knob 2
The control waveform cycle uses the patch
specific tempo (→ p. 38) as reference and is
displayed as eighth note, quarter note, or quarter
note x numeral (see table on page 39).
The numeral after x (2 – 20) indicates the
duration of a cycle in multiple quarter notes.
When "2" is selected, the control waveform
changes in a cycle interval that corresponds to
half a note of the patch specific tempo. When
"4" is selected, the cycle is 4 beats (1 measure of
a 4/4 time signature).
HINT
When the "ARRM BPM" parameter is a ssigned
to the expression pedal, the reference tem po for
the ARRM function (0 – 25 0) can be controlled
with the pedal. For information on h ow to
assign control targets to the expression ped al,
see page 31. The expression pedal movement
will not change the patch specifi c tempo.
When the ARRM settin g is
8.
complete, press the [E XIT] key.
The unit returns to manual mode or play mode.
Store the patch as necessary.
NOTE
Any changes in ARRM setti ngs will be lost when
you select a new patch. Be sure to store the
patch if you want to keep the changes (→ p. 27).