38 ZOOM B9.1ut
Using the Foot Switche s

Assigning modules to

foot switches 1 – 4

In manual mode, the foot switches 1 – 4 can be
used to turn specific modules on and off. This
section explains how to assign modules to the
switches.

In manual mode or play mode,

1.

select the patch.

HINT

Functions assigned to the foot swit ches 1 – 4 are
specifi c to each patch.

Press the [FOOT SW] key twic e.

2.

The display changes as follows.
-VV[:>(ZZPNUl*47w(47p46+o+3@
Modules assigned to the foot switches 1 – 4
Press key twice

HINT

The foot switch 1 – 4 setting is includ ed in the
TOTAL/FUNCTION module for the p atch. The
above display can also be called up b y pressing
the [TOTAL/FUNCTION] key in the ef fect
module key section and then t urning the [TYPE]
knob.

Use the parameter knob s 1 – 4

3.

to select the functio n for foot

switches 1 – 4.

The parameter knob number corresponds to the
foot switch number.
For example, to select a module to assign to foot
switch 1, turn parameter knob 1.
The following modules can be assigned to the
respective foot switches.
• Foot swi tch 1
COMP module (CMP) or WAH/EFX1
module (WAH)
• Foot swi tch 2
PRE-AMP module (AMP) or EXT LOOP
module (ExL)
• Foot swi tch 3
MOD/EFX2 module (MOD) or EQ module
(EQ)
• Foot swi tch 4
DELAY module (DLY) or REVERB module
(REV)

HINT

The names of the two modules th at can be
assigned to each foot switch are printe d on the
panel to the right of the switch. The cu rrently
selected module is indicated b y the respective
LED which is either lit (module on) or fl ashing
(module off).

NOTE

Any changes in assignment settings wil l be lost
when you select a new patch. Be sure to store
the patch if you want to keep the changes (→ p.
27).

Specifying the tempo

for a patch

The B9.1ut lets you specify a tempo for each
individual patch and synchronize specif ic
parameters to this tempo in note units. This
section explains how to specify and use the
tempo setting for a patch.

In manual mode or play mode,

1.

select the patch.

Press the [TOTAL/FUNCTION ]

2.

effect module key.

The tempo setting for each patch is part of the
[TOTAL/FUNCTION] module.
When you press the [TOTAL/FUNCTION]
effect module key, the display changes as
follows.