64 ZOOM B9.1ut
How to read the parameter table
Effect Types and ParametersThis is a delay module that allows use of the hold function. Effect parameters are described after the listing of
effect types.
Delay
This is a long delay with a maximum set ting of 5000 ms.
PingPongDly (Ping Pong Delay)
This is a ping-pong type delay where the delay sound alternates between left and right.
This effect simulates an analog delay with a long delay time of up to 5000 ms.
The above fi ve effect types have the same parameters.
PARM1 PARM2 PARM3 PARM4
Time
1 – 5000ms
FeedBack
0 – 100
HiDamp
0 – 10
Mix
0 – 100
Sets the delay time. Adjusts the feedback amount. Adjusts the treble attenuation of the
delay sound.
Adjusts the balance between
original sound and effect sound.
ReverseDelay
This is a reverse delay with a long dela y time of up to 2500 ms.
PARM1 PARM2 PARM3 PARM4
Time
10 – 2500ms
FeedBack
0 – 100
HiDamp
0 – 10
Balance
0 – 100
Sets the delay time. Adjusts the amount of feedback. Adjusts the treble attenuation of the
delay sound.
Adjusts the balance between
original sound and effect sound.
DELAY module
Tempo sync
The note symbol ( ) in the table indicate s that the parameter can be sync hronized to
the patch specific tempo. If you sele ct the note symbol as a value for the parame ter
when making the setting at the B9.1ut, the parameter value will be synchronized to
the patch specific tempo in note uni ts (→ p. 38).
Expression pedal
The pedal symbol ( ) in the table indi cates that the parameter can be contro lled
with the built-in expression ped al. If you select the parameter as co ntrol target when
making the setting at the B9.1ut (→ p. 31), the expression pedal will adjust the
parameter in real time when the pa tch is selected. Parameters wit h the pedal symbol
can also be selected as control t argets for the ARRM function.
Delay tap/hold delay/dela y mute/hold synth
The , , , and indications in the table show that the
respective function foot switch 1 – 3 ca n be used to specify the delay time (TAP),
toggle hold delay on and off (HOLD), togg le delay mute input between on and off
(MUTE), and toggle hold synth on and off (SYNTH). These functions apply to the
DELAY module (TAP, HOLD, MUTE) or the PRE-AMP module (SYNTH).
To use these functions, the respective f unction must be assigned to the f unction foot
switch 1 – 3 (→ p. 36) and the respective effect t ype must be enabled.
Effect parameters 1 – 4
Effect type
When this effect type is selected, the four parameters listed here
can be adjusted with parameter knobs 1 − 4. The setting range
for each parameter is also shown. Some effect parameters are
adjusted with the knobs of the pre-amp section.