Prestige 128IMH ISDN Modem/ Router/Hub
Step 2. Put the SMT in command interpreter (CI) mode by entering 8 in Menu 24 – System Maintenance.
Step 3. Enter command “sys stdio 0” to disable SMT timeout, so the TFTP transfer will not be interrupted.
Step 4. Launch TFTP client on your workstation and connect to the Prestige. Set the transfer mode to binary before starting data transfer.
Step 5. Use the TFTP client to transfer files between the Prestige and the workstation. The file name for the firmware is “ras” and for the configuration file,
If you upload the firmware to the Prestige, it will reboot automatically when the file transfer is completed.
Note that the telnet connection must be active and the SMT in CI mode before and during the TFTP transfer. For details on TFTP commands, please consult the documentation of your TFTP client program. For UNIX, use “get” to transfer from the Prestige to the workstation, “put” the other way around, and “binary” to set binary transfer mode.
14.6.4 Boot module commands
Prestige boot module commands are shown below. For ATBAx, x denotes the number preceeding the colon to give the baud rate following the colon in the list of numbers that follows; e.g. ATBA3 will give a baud of 9.6 kbps. ATSE displays the seed that is used to generate a password to turn on the debug flag in the firmware. The ATSH command shows product related information such as boot module version, vendor name, product model, RAS code revision, ISDN code revision, etc.
System Maintenance |
