Prestige 128IMH ISDN Modem/ Router/Hub
5.1.1 Remote Node Setup
Follow the procedure in Chapter 5 - Remote Node Configuration to configure the protocol- independent parameters in Menu 11 - Remote Node Profile. For the TCP/IP parameters, follow the instructions below. If you are configuring your Prestige to receive incoming calls, you also need to set the default
Follow the steps below to edit Menu 11.3 - Remote Node Network Layer Options shown below.
In Menu 11.1, make sure IP is among the protocols in the Route field. (The Route field should display Route = IP or Route = IP + IPX.)
Move the cursor to the Edit IP/IPX/Bridge field, then press the space bar to toggle and set the value to Yes. Press [Enter] to open Menu 11.3 - Network Layer Options.
Menu 11.3 - Remote Node Network Layer Options
IP Options: | IPX Options: | |
Rem IP Addr: 0.0.0.0 | ||
Rem Subnet Mask= 0.0.0.0 | Rem LAN Net #= N/A | |
My WAN Addr= 0.0.0.0 | My WAN Net #= N/A | |
Single User Account= No | Hop Count= N/A | |
| Tick | Count= N/A |
Metric= 2 | W/D | Spoofing(min)= N/A |
Private= No | SAP/RIP Timeout(min)= N/A | |
RIP Direction= Both |
|
|
Version= | Bridge Options: | |
| ||
| Ethernet Addr Timeout(min)= N/A |
Enter here to CONFIRM or ESC to CANCEL:
Figure 5-2 Menu 11.3- Remote Node TCP/IP Options
Remote Node TCP/IP Configuration |