ZyXEL Communications 128IMH manual IPX Remote Node Setup, Menu 11.3 Remote Node Novell IPX Options

Prestige 128IMH ISDN Modem/ Router/Hub

6.5.1 IPX Remote Node Setup

Follow the procedure in Chapter 5 to configure the protocol-independent parameters in Menu

11.1- Remote Node Profile. For the IPX-specific parameters in Menu 11.3 - Remote Node Network Layer Options, follow the instructions below. If you want the Prestige to receive incoming calls, you must also configure the default dial-in parameters in Menu 13.

To edit Menu 11.3 - Remote Node Network Layer Options shown below, follow these steps:

Step 1. In Menu 11.1, make sure IPX is among the protocols in the Route field. (The Route field should display Route = IPX or Route = IP + IPX.)

Step 2. Move the cursor to the Edit IP/IPX/Bridge field, then press the space bar to select Yes and press [Enter] to open Menu 11.3 - Network Layer Options.

Menu 11.3 - Remote Node Network Layer Options

IP Options:	IPX Options:
Rem IP Addr:	Dial-On-Query= No
Rem Subnet Mask= N/A	Rem LAN Net #= 00000000
My WAN Addr= N/A	My WAN Net #= 00000000
Single User Account= N/A	Hop Count= 1
Server IP Addr= N/A	Tick	Count= 2
Metric= N/A	W/D	Spoofing(min)= 3
Private= N/A	SAP/RIP Timeout(min)= 3
RIP Direction= N/A
Version= N/A	Bridge Options:
	Dial-On-Broadcast= N/A
	Ethernet Addr Timeout(min)= N/A

Enter here to CONFIRM or ESC to CANCEL:

Figure 6-5 Menu 11.3 - Remote Node Novell IPX Options

6-8 IPX Configuration