Prestige 2602H/HW Series User’s Guide

• Internal Calls (see Section 10.3 on page 159)

Note: To take full advantage of the supplementary phone services available though the Prestige's phone ports, you may need to subscribe to the services from your voice service provider.

9.12.1 The Flash Key

Flashing means to press the hook for a short period of time (a few hundred milliseconds) before releasing it. On newer telephones, there should be a "flash" key (button) that generates the signal electronically. If the flash key is not available, you can tap (press and immediately release) the hook by hand to achieve the same effect. However, using the flash key is preferred since the timing is much more precise. With manual tapping, if the duration is too long, it may be interpreted as hanging up by the Prestige.

You can invoke all the supplementary services by using the flash key.

9.12.2Europe Type Supplementary Phone Services

This section describes how to use supplementary phone services with the Europe Type Call Service Mode. Commands for supplementary services are listed in the table below.

After pressing the flash key, if you do not issue the sub-command before the default sub- command timeout (2 seconds) expires or issue an invalid sub-command, the current operation will be aborted.

Table 43 European Flash Key Commands

COMMAND

SUB-COMMAND

DESCRIPTION

 

 

 

Flash

 

Put a current call on hold to place a second call.

 

 

Switch back to the call (if there is no second call).

 

 

 

Flash

0

Drop the call presently on hold or reject an incoming call which is

 

 

waiting for answer.

Flash

1

Disconnect the current phone connection and answer the incoming

 

 

call or resume with caller presently on hold.

Flash

2

1.

Switch back and forth between two calls.

 

 

2.

Put a current call on hold to answer an incoming call.

 

 

3.

Separate the current three-way conference call into two

 

 

individual calls (one is on-line, the other is on hold).

Flash

3

Create three-way conference connection.

 

 

 

Flash

*98#

Transfer the call to another phone.

 

 

 

 

9.12.2.1 European Call Hold

Call hold allows you to put a call (A) on hold by pressing the flash key.

If you have another call, press the flash key and then “2” to switch back and forth between caller A and B by putting either one on hold.

Chapter 9 Voice Screens

151