Prestige 2602H/HW Series User’s Guide

Figure 168 Menu 11.1 Remote Node Profile

Menu 11.1 - Remote Node Profile

Rem Node Name= MyISP

Route= IP

Active= Yes

Bridge= No

Encapsulation= PPPoE

Edit IP/Bridge= No

Multiplexing= LLC-based

Edit ATM Options= No

Service Name=

Edit Advance Options= Yes

Incoming:

Telco Option:

Rem Login=

Allocated Budget(min)= 0

Rem Password= ********

Period(hr)= 0

Outgoing:

Schedule Sets=

My Login= ?

Nailed-Up Connection= No

My Password= ?

Session Options:

Authen= CHAP/PAP

Edit Filter Sets= No

 

Idle Timeout(sec)= 0

Press ENTER to Confirm or ESC to Cancel:

Move the cursor to the Edit Advance Options field, press [SPACE BAR] to select Yes, then press [ENTER] to display Menu 11.8 – Advance Setup Options.

Figure 169 Menu 11.8 Advance Setup Options

Menu 11.8 - Advance Setup Options

PPPoE pass-through= No

Press ENTER to Confirm or ESC to Cancel:

The following table describes the fields in this menu.

Table 115 Menu 11.8 Advance Setup Options

FIELD

DESCRIPTION

 

 

PPPoE pass-through

Press [SPACE BAR] to select Yes and press [ENTER] to enable PPPoE pass

 

through. In addition to the Prestige's built-in PPPoE client, you can enable

 

PPPoE pass through to allow up to ten hosts on the LAN to use PPPoE client

 

software on their computers to connect to the ISP via the Prestige. Each host

 

can have a separate account and a public WAN IP address.

 

PPPoE pass through is an alternative to NAT for applications where NAT is

 

not appropriate.

 

Press [SPACE BAR] to select No and press [ENTER] to disable PPPoE pass

 

through if you do not need to allow hosts on the LAN to use PPPoE client

 

software on their computers to connect to the ISP.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm or ESC to Cancel:” to save your configuration, or press [ESC] at any time to cancel.

328

Chapter 29 Remote Node Configuration