Prestige 2602H/HW Series User’s Guide

Table 113 Menu 11.1 Remote Node Profile (continued)

FIELD

DESCRIPTION

 

 

 

PAP – accept PAP (Password Authentication Protocol) only.

 

 

Route

This field determines the protocol used in routing. Options are IP and None.

 

 

Bridge

When bridging is enabled, your Prestige will forward any packet that it does not

 

route to this remote node; otherwise, the packets are discarded. Select Yes to

 

enable and No to disable.

Edit IP/Bridge

Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.3 –

 

Remote Node Network Layer Options.

Edit ATM Options

Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.6 –

 

Remote Node ATM Layer Options.

Edit Advance

This field is only available when you select PPPoE in the Encapsulation field.

Options

Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.8 –

 

Advance Setup Options.

Telco Option

 

 

 

Allocated Budget

This sets a ceiling for outgoing call time for this remote node. The default for this

(min)

field is 0 meaning no budget control.

Period (hr)

This field is the time period that the budget should be reset. For example, if we

 

are allowed to call this remote node for a maximum of 10 minutes every hour,

 

then the Allocated Budget is (10 minutes) and the Period (hr) is 1 (hour).

Schedule Sets

This field is only applicable for PPPoE and PPPoA encapsulation. You can apply

 

up to four schedule sets here. For more details please refer to Chapter 42 on

 

page 419.

Nailed up

This field is only applicable for PPPoE and PPPoA encapsulation. This field

Connection

specifies if you want to make the connection to this remote node a nailed-up

 

connection. More details are given earlier in this section.

Session Options

 

 

 

Edit Filter Sets

Use [SPACE BAR] to choose Yes and press [ENTER] to open menu 11.5 to edit

 

the filter sets. See the Remote Node Filter section for more details.

Idle Timeout (sec)

Type the number of seconds (0-9999) that can elapse when the Prestige is idle

 

(there is no traffic going to the remote node), before the Prestige automatically

 

disconnects the remote node. 0 means that the session will not timeout.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm or ESC to Cancel:” to save your configuration, or press [ESC] at any time to cancel.

29.2.3 Outgoing Authentication Protocol

For obvious reasons, you should employ the strongest authentication protocol possible. However, some vendors’ implementation includes specific authentication protocol in the user profile. It will disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated protocol is stronger than specified. If the peer disconnects right after a successful authentication, make sure that you specify the correct authentication protocol when connecting to such an implementation.

322

Chapter 29 Remote Node Configuration