Prestige 2602H/HW Series User’s Guide

Figure 236 Telnet into Menu 24.6

Menu 24.6 -- System Maintenance - Restore Configuration

To transfer the firmware and configuration file to your workstation, follow the procedure below:

1.Launch the FTP client on your workstation.

2.Type "open" and the IP address of your Prestige. Then type "root" and SMT password as requested.

3.Type "put backupfilename rom-0" where backupfilename is the name of

your backup configuration file on your

workstation and rom-0 is the

remote file name on the Prestige. This

restores the

configuration

to

your Prestige.

a successful

file transfer

 

4. The system reboots automatically after

 

For details on FTP commands, please consult the documentation of your FTP client program. For details on backup using TFTP (note that you must remain in this menu to back up using TFTP), please see your Prestige manual.

Press ENTER to Exit:

1Launch the FTP client on your computer.

2Enter “open”, followed by a space and the IP address of your Prestige.

3Press [ENTER] when prompted for a username.

4Enter your password as requested (the default is “1234”).

5Enter “bin” to set transfer mode to binary.

6Find the “rom” file (on your computer) that you want to restore to your Prestige.

7Use “put” to transfer files from the Prestige to the computer, for example, “put config.rom rom-0” transfers the configuration file “config.rom” on your computer to the Prestige. See earlier in this chapter for more information on filename conventions.

8Enter “quit” to exit the ftp prompt. The Prestige will automatically restart after a successful restore process.

38.3.2Restore Using FTP Session Example

Figure 237 Restore Using FTP Session Example

ftp> put config.rom rom-0 200 Port command okay

150 Opening data connection for STOR rom-0

226 File received OK

221 Goodbye for writing flash

ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec. ftp>quit

Refer to Section 38.2.5 on page 392 to read about configurations that disallow TFTP and FTP over WAN.

Chapter 38 Firmware and Configuration File Maintenance

395