ES-4024A Series Switch Support Notes
Configuring your Switch to fulfill this scenario (CLI)
1.Connect the Switch Console port with your PC or Notebook.
2.Open your Terminal program.(Ex, Hyper Terminal in Windows System)
3.Make sure that your port settings are bps:9600
Data bits:8 Parity: None Stop bits:1
Flow control: None:
4.After you connected successfully, give the correct user name and password.
5.Put “en” or “enable” to go into the privileged mode. Then put “config” to go into the configuration mode.
6.Put the following commands to setup Port Based VLAN on your Switch in this
40
All contents copyright (c) 2006 ZyXEL Communications Corporation.
