ZyXEL Communications GS1900 Port, Delay, Count, Apply, Cancel, Interval, Transmission, 8192 seconds, LLDP-MEDFast, Start Repeat, Transmit Delay, Hold Multiplier, Reinitialization

Chapter 26 Configuration: LLDP

Table 117 Configuration > LLDP > Global (continued)

LABEL	DESCRIPTION
Transmission	Enter the transmission interval value.
Interval	The switch periodically transmits LLDP frames to its neighbors for having the network
	discovery information up-to-date. The interval between each LLDP frame is determined by
	the Tx Interval value. Valid values are restricted to 5 - 32768 seconds.
Hold Multiplier	Enter the hold multiplier value.
	Each LLDP frame contains information about how long the information in the LLDP frame
	shall be considered valid. The LLDP information valid period is set to Tx Hold multiplied by
	Tx Interval seconds. Valid values are restricted to 2 - 10 times.
Reinitialization	Enter the reinitialization delay value.
Delay	When a port is disabled, LLDP is disabled or the switch is rebooted, an LLDP shutdown
	frame is transmitted to the neighboring units, signalling that the LLDP information isn't
	valid anymore. Tx Reinit controls the amount of seconds between the shutdown frame and
	a new LLDP initialization. Valid values are restricted to 1 - 10 seconds.
Transmit Delay	Enter the transmission delay value.
	If some configuration is changed (e.g. the IP address) a new LLDP frame is transmitted, but
	the time between the LLDP frames will always be at least the value of Tx Delay seconds. Tx
	Delay cannot be larger than 1/4 of the Tx Interval value. Valid values are restricted to 1 -
	8192 seconds.
LLDP-MED Fast	Enter the LLDP-MED fast start repeat count value.
Start Repeat	Because there is a risk of an LLDP frame being lost during transmission between neighbors,
Count
	it is recommended to repeat the fast start transmission multiple times to increase the
	possibility of the neighbors receiving the LLDP frame. With Fast start repeat count it is
	possible to specify the number of times the fast start transmission would be repeated. The
	recommended value is 4 times, given that 4 LLDP frames with a 1 second interval will be
	transmitted, when an LLDP frame with new information is received.
Apply	Click Apply to save the changes.
Cancel	Click Cancel to discard the changes.

26.2.2 The Port Screen

Use this screen to view the Port settings. Click Configuration > LLDP > Port to open this screen.

154
	GS1900 Series User’s Guide