ZyXEL Communications GS1900 7.4 Bandwidth Management, Port, Click, Burst, Power(W), Power (W), Remaining, Port Rate, on a port, Egress Global, Allocated Power(W), Egress Global Burst

Chapter 7 Monitor: Port

Table 26 Monitor > Port > PoE

LABEL	DESCRIPTION
Allocated Power(W)	This field displays the total amount of power the Switch has reserved for PoE after
	negotiating with the connected PoE device(s).
	Consuming Power (W) can be less than or equal but not more than the Allocated
	Power (W).
Remaining	This field displays the amount of power the Switch can still provide for PoE.
Power(W)	Note: The Switch must have at least 16 W of remaining power in order to supply power
	to a PoE device, even if the PoE device needs less than 16 W.

7.4 Bandwidth Management

This section shows you the maximum bandwidth using the Bandwidth Management screen. Bandwidth management shows themaximum allowable bandwidth for incoming and/or out-going traffic flows on a port.

7.4.1 Bandwidth Control

Use this screen to view the Switch’s bandwidth control in egress global burst and port rate.

An egress port is an outgoing port, that is, a port through which a data packet leaves for both ports. An ingress port is an incoming port, that is, a port through which a data packet enters.

Click Monitor > Port > Bandwidth Management > Bandwidth Control to access this screen.

Figure 38 Monitor > Port > Bandwidth Management > Bandwidth Control

Each field is described in the following table.

Table 27 Monitor > Port > Bandwidth Management > Bandwidth Control

LABEL	DESCRIPTION
Egress Global Burst
Egress Global	This field specifies the current egress burst size in bytes all ports.
Burst
Port Rate	View the maximum bandwidth allowed in kilobits per second (Kbps) for the traffic flow
	on a port.
Port	This field displays the port number.

56
	GS1900 Series User’s Guide