ZyXEL Communications 56K II, 56K Plus II, Omni 56K II 5.1.4Extended AT# Command Sets, Table 5-5Extended AT# Command Sets

Omni 56K II and Omni 56K Plus II User’s Guide

COMMAND	OPTIONS	FUNCTION & DESCRIPTION	REF.
	Note: The command *Gn requests supervisor password checking.
	1. In security type 1, the remote site must be a ZyXEL modem.
	2. In security type 2, the remote site can be any other type of modem.
	3. The modem can store 4 (0-3) telephone numbers. If callback security is disabled, the
	modem will search the password table to check the remote modem's password. If they
	match, the modem keeps the connection, otherwise the modem will hang up. If callback
	security is enabled, the modem will complete the password checking. If there is no match,
	the modem disconnects the line, otherwise the modem disconnects the line and find the
	corresponding phone number and call back immediately. The remote modem should be set
	to automatically answer the call and response.
*HS		Modifies the supervisor password.
		Note: The default supervisor password is ZyXEL.
*Hn	N=0-3	Modifies the user password table at location 'n.'
*Pn	n=0-15	Set transmission power level; ranges from -8 dBm	S17.1-4
	*P9 *	to -15 dBm. (Default: -11 dBm)
*Qn		Action taken when line quality changes.	S27.6-7
	*Q0	The modem will not act on poor signal quality.
	*Q1	Retrain action taken if signal quality is poor. (See
		also S41.2)
	*Q2 *	Adaptive rate, automatic fall-back or forward.
	*Q3	Disconnect if the signal quality is poor.
*T		Recall the last CND (Caller ID) information.	S40.2
*V		Views password table.

5.1.4Extended AT# Command Sets

Table 5-5 Extended AT# Command Sets

COMMAND	OPTIONS	FUNCTION & DESCRIPTION	REF.
#En		Modem status in escape state
	#E0	This disables the reporting of modem status when it is in escape
		state
	#E1	This enables the reporting of modem status when in escape state

5-10 Command Sets