ZyXEL Communications 56K II, 56K Plus II, Omni 56K II 5.2.3Service Class 2.0 Commands, Class 2 Flow Control, Table 5-11Service Class 2.0 Commands

Omni 56K II and Omni 56K Plus II User’s Guide

RESPONSE	VALUE	FUNCTION AND DESCRIPTION
		command.
+FTSI:"string"		Report the remote ID response TSI.
+FVOICE		Changes to voice response.

Class 2 Flow Control

Flow control is necessary to match the DTE-DCE data rate to the line-signaling rate while transmitting or receiving Group 3 (T.4) data. In Class 2 fax mode, both hardware (RTS/CTS) and software (XON/XOFF) flow control are enabled.

5.2.3Service Class 2.0 Commands

Table 5-11 Service Class 2.0 Commands

COMMAND	DESCRIPTION	VALUE
+FDT	Transmit a phase C data command.
	This command releases the DCE to
	proceed with the negotiation.
+FDR	Receive a phase C data command.
	This command initiates document
	reception.
+FKS	Terminates a Session, orderly fax
	abort.
+FIP	Initialize the Service Class 2.0
	Parameters.
+FCLASS=n	Service Class Identification and Control	n=0,1,2.0,8;refer to the
		+FCLASS Class 1 command
+FMI?	Identify DCE Manufacturer	ZyXEL
+FMM?	Identify DCE	Omni 56K II/Omni 56K Plus II
+FMR?	Identify DCE Revision	Vx.x
+FCC=vr,br,wd,In,df,ec,bf,st	Establish DCE Capabilities
	Vertical Resolution	vr=0:Normal;98 lpi
		vr=1:Fine;196 lpi

5-18 Command Sets