ZyXEL Communications 56K II, 56K Plus II, Omni 56K II manual 79

Omni 56K II and Omni 56K Plus II User’s Guide

COMMAND	BIT	DEC	HEX	FUNCTION AND DESCRIPTION	REF.
	7	128	80	Ignore calling tone, not to be used as fax detection.
S42=	bit	dec	hex	Bit-mapped register.
	1	2	2	Enables throughput averaging.	2
	2	4	4	A CND message forces on even if ATQ2 is set.
	3	8	8	This disables the escape sequence code in answer
				mode.
	4	16	10	This disables the V.17 14,400 Fax in calling mode and
				no effect on answering mode.
	6	64	40	This disables the 'RINGING' result code.	Xn
	7	128	80	The DCD is forced on but pulses off for 0.5 second at	&C0
				carrier loss.
S43=	bit	dec	hex	Bit-mapped register.	+008
	6	64	40	Enable a 1.5 second pause between off-hook and
				modem answering.
	7	128	80	The modem hangs-up if the line condition does not
				permit the modem to run at the highest speed set by
				'&Nn' command.
S44=	bit	dec	hex	Bit-mapped register.	+000
	3	8	8	ATDSn initiates auto-dial of the stored numbers	DSn
				consecutively until a connection is made (cyclic dial).
	4	16	10	DSR follows DTR (see also S41.5).	&S1
	6	64	40	When selected with ‘&B0’, DTE speed is fixed at	&Bn
				38400 when the link speed is above 9600. DTE speed
				is fixed at 9600 if the link speed is 7200. If it is below
				7200, the DTE speed follows link speed. When
				selected with &B1, DTE speed is fixed at the current
				rate when an ARQ connection is made. When a non-
				ARQ connection is made, DTE speed follows the link
				speed (See also S18).
S45=		dec	hex	The delay during which the CND silence detection is	+100
		0-255	0-FF	disabled, in 20 ms units (see also S46).
S46=		dec	hex	The CND silence detection interval.	+028

Command Sets 5-33