ZyXEL Communications 56K II, 56K Plus II, Omni 56K II 5.2.2Service Class 2 Commands, Table 5-8Service Class 2 Command Syntax, Table 5-9Service Class 2 Commands Supported Commands (per TIA PN2388 8/20/90)

Omni 56K II and Omni 56K Plus II User’s Guide

5.2.2Service Class 2 Commands

The following Class 2 commands are supported and implemented as per TIA PN2388 (8/20/90):

Table 5-8 Service Class 2 Command Syntax

COMMAND SYNTAX	DESCRIPTION
+<command>=<value>	Execute a command or set a parameter.
+<command>=?	Read permissible settings.
+<command>?	Read current setting.

Table 5-9 Service Class 2 Commands Supported Commands (per TIA PN2388 8/20/90)

COMMAND	DESCRIPTION	VALUE
+FAA=n	Automatic answer mode parameters.
	Answer as set by +FCLASS.	n=0
	DCE answers and automatically determines the type of call.	n=1
+FBADLIN=	Bad line threshold (number of consecutive bad lines for a bad page	0-255
<value>	parameter).
	Determine if Copy Quality is OK on the T.30 flow chart. A value of 0
	implies that error checking is disabled.
+FBOR=n	Phase C data bit order:
	Select direct bit order.	n=0
	Select reversed bit order in receiving mode for phase C data.	n=1
+FBUF?	Buffer size. This Read Only parameter allows the DTE to determine the
	characteristics of the DCE’s buffer size.
+FCIG="string"	Sets the local fax station ID string that is sent to polling Rx.
+FCLASS=n	Service class selection. Refer to the +FCLASS Service Class 1 command
	in Table 5-6.
+FCON	DCE automatically responds to a fax connection.
+FCQ=n	Sets the copy quality check capability parameters.
	Disables the copy quality check capability.	n=0

Command Sets 5-13