P-660R/H-D Series User’s Guide

Note: Do not edit filter sets 11 and 12. They are used exclusively by the web configurator. Any rules you configured in sets 11 and 12 will be erased and replaced when you apply the web configurator-generated filter rules.

23.5 Editing ATM Layer Options

Follow the steps shown next to edit Menu 11.6 – Remote Node ATM Layer Options.

In menu 11.1, move the cursor to the Edit ATM Options field and then press [SPACE BAR] to select Yes. Press [ENTER] to display Menu 11.6 – Remote Node ATM Layer Options.

There are two versions of menu 11.6 for the Prestige, depending on whether you chose VC- based/LLC-basedmultiplexing and PPP encapsulation in menu 11.1.

23.5.1 VC-based Multiplexing (non-PPP Encapsulation)

For VC-basedmultiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, for example, VC1 will carry IP. Separate VPI and VCI numbers must be specified for each protocol.

Figure 120 Menu 11.6 for VC-based Multiplexing

 

Menu 11.6 - Remote Node ATM

Layer

Options

 

VPI/VCI (VC-Multiplexing)

 

VC Options for IP:

VC Options for Bridge:

VPI #=

8

VPI

#= 1

 

VCI #=

35

VCI

#= 36

 

ATM QoS Type= CBR

ATM

QoS Type= N/A

Peak Cell Rate (PCR)= 0

Peak Cell

Rate (PCR)= N/A

Sustain Cell Rate (SCR)= 0

Sustain Cell Rate (SCR)= N/A

Maximum Burst Size (MBS)= 0

Maximum Burst Size (MBS)= N/A

Enter here to CONFIRM or ESC to CANCEL:

23.5.2 LLC-based Multiplexing or PPP Encapsulation

For LLC-basedmultiplexing or PPP encapsulation, one VC carries multiple protocols with protocol identifying information being contained in each packet header.

219

Chapter 23 Remote Node Configuration