ZyWALL 10 Internet Security Gateway
Menu 24.6 replaces the current configuration with your customized configuration you
backed up previously. Menu 24.7.2 shows you the instructions for uploading the Router Configuration file that replaces the current configuration file with the default configuration file, i.e., zywall.rom. You will lose all configurations that you had before and the speed of the console port will be reset to the default of 9600 bps with 8 data bit, no parity and 1 stop bit (8n1). You will need to change your serial communications software to the default before you can connect to the ZyWALL again. The password will be reset to the default of 1234, also.
Follow the procedure below to upload the configuration file: Step 1. Enter y at the prompt to go into debug mode.
Step 2. Enter atlc after the Enter Debug Mode message.
Step 3. Wait for the Starting XMODEM upload message before activating Xmodem upload on your terminal (Xmodem upload will be similar to the previous example for uploading firmware).
Step 4. After successful firmware upload, enter atgo to restart the ZyWALL.
Menu 24.7.2 - System Maintenance - Upload Router Configuration File
To upload router configuration file:
1.Enter "y" at the prompt below to go into debug mode.
2.Enter "atlc" after "Enter Debug Mode" message.
3.Wait for "Starting XMODEM upload" message before activating Xmodem upload on your terminal.
4.After successful configuration file upload, enter "atgo" to restart the router.
Warning:
1.Proceeding with the upload will erase the current configuration file.
2.The router's console port speed (Menu 24.2.2) may change when it is restarted; please adjust your terminal's speed accordingly. The password may change (menu 23), also.
3.When uploading the DEFAULT configuration file, the console port speed will be reset to 9600 bps and the password to "1234".
Do You Which To Proceed:(Y/N)
Figure10.5 TFTP File Transfer
In addition to the direct console port connection, the ZyWALL supports the up/downloading of the firmware and the configuration file using TFTP (Trivial File Transfer Protocol) over LAN. Although TFTP should work over WAN as well, it is not recommended.
To use TFTP, your workstation must have both telnet and TFTP clients. To transfer the firmware and the configuration file, follow the procedure shown next:
Firmware and Configuration File Maintenance |