Husqvarna 15V2s AWD manual Check the safety system

Page 24

Maintenance

Check the safety system

The machine is equipped with a safety system that prevents starting or driving under the following conditions.

The engine should only be possible to start when the cutting unit is in its raised position and the hydrostat pedals are in the neutral position. Rider 15V2 AWD, the engine can not be started if the parking brake is not pressed down.

The driver does not need to be seated in the driver’s seat.

Make daily inspections to ensure that the safety system works by attempting to start the engine when one of the conditions is not met. Change the conditions and try again.

Check that the engine stops if you temporarily move out off the driver’s seat while the cutting unit is lowered or the hydrostat pedals are not in the neutral position.

Rider 15V2

Rider 15V2 AWD, Rider 15V2s AWD

Start motor

Ignition system

Works

Does not work

24 – English

Image 24

Contents Rider 15V2 Rider 15V2 AWD Rider 15V2s AWD EnglishContents Service journal Pre-delivery serviceAfter the ﬁrst 8 hours Introduction Dear CustomerDriving and transport on public roads TowingGood service Serial NumberKEY to Symbols SymbolsBrake Starting instructions Safety Instructions Safety instructionsInsure your Rider General useDriving on slopes This is what you doMaintenance ChildrenTransport What is WHAT? Location of the controlsPresentation Cutting height adjustment lever Cutting unitLifting lever for the cutting unit LightsExercise care and refuel outdoors see safety instructions FuellingRelease lever Release lever Rider 15V2 AWDDriving Before startingStart the engine Starting the engine with a weak battery Connecting the jump leadsDriving the Rider Remove the cables in the reverse orderCutting tips Stop the engineOther objects which can be thrown out by the blades Maintenance Maintenance scheduleCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Adjusting the parking brake Rider Adjusting the parking brake Rider 15V2 AWDChecking and adjusting of throttle wire Can result in reduced braking abilityChecking and adjusting the choke wire Replacement of fuel ﬁlterReplacing the air ﬁlter Cool before starting to replace the air ﬁlterCheck the level of the battery acid Dry-charged battery Checking the fuel pump’s air ﬁlterIgnition system Replacing the spark plugCheck the safety system Replacing the light bulbs Main fuseWhen the engine is running. Mind your ﬁngers Checking the tyre pressureChecking the engine’s cooling air intake Fitting the cutting headRemoving the cutting unit Trapping your handAdjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belts Service position for the cutting unit Placing in the service positionRestoring from service position Checking the bladesRemoving the BioClip plug Lubrication Checking the engine’s oil levelChanging the oil ﬁlter Replacing the engine oilLubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Troubleshooting schedule Problem ProcedureService StorageWinter storage GuardTechnical data EC-declaration of conformity Applies to Europe only Page ´z+S!r¶6H¨ Page 1151018-26 ´z+S!r¶6H¨ ´z+S!r¶6H¨