Husqvarna 15V2s AWD manual Good service, Serial Number

Page 5

INTRODUCTION

Good service

Husqvarna products are sold all over the world and only through servicing dealers. This is to ensure that you, the customer, get the best support and service. For example, before this machine was delivered it was inspected and adjusted by your dealer. See the certificate in the Service Journal in this manual.

When you need spare parts or advice on service issues, warranty terms, etc., contact:

This Operator’s Manual belongs to machine with serial number:

Engine

Transmission

Serial Number

The serial number can be found on the printed plate attached to the front, left-hand side under the seat. Stated on the plate, from the top are:

The machines type designation.

The manufacturer’s type number.

The machine’s serial number.

State the type designation and serial number when ordering spare parts.

The engine serial number is given on a bar code decal. This is located on the left side of the crankcase, in front of the starter motor. The sign states:

Model

Type

Code.

Please quote when ordering parts.

The transmission’s serial number on hydrostatic machines is stated on the barcode decal located on the front of the housing on the left-hand drive axle:

Type designation is stated above the barcode and starts with the letter ”K”.

The serial number is stated above the barcode and has the prefix “s/n”.

The manufacturer’s type number is stated under the barcode and has the prefix “p/n”. State the type designation and serial number when ordering spare parts.

English – 5

Image 5
Contents English Rider 15V2 Rider 15V2 AWD Rider 15V2s AWDContents After the first 8 hours Service journalPre-delivery service Dear Customer IntroductionDriving and transport on public roads TowingSerial Number Good serviceSymbols KEY to SymbolsBrake Starting instructions Safety instructions Safety InstructionsInsure your Rider General useThis is what you do Driving on slopesChildren MaintenanceTransport Location of the controls What is WHAT?Presentation Cutting unit Cutting height adjustment leverLifting lever for the cutting unit LightsFuelling Exercise care and refuel outdoors see safety instructionsRelease lever Release lever Rider 15V2 AWDStart the engine DrivingBefore starting Connecting the jump leads Starting the engine with a weak batteryDriving the Rider Remove the cables in the reverse orderOther objects which can be thrown out by the blades Cutting tipsStop the engine Maintenance schedule MaintenanceRemoving of the machine hoods CleaningChecking and adjusting the steering wires Adjusting the parking brake Rider 15V2 AWD Adjusting the parking brake RiderChecking and adjusting of throttle wire Can result in reduced braking abilityReplacement of fuel filter Checking and adjusting the choke wireReplacing the air filter Cool before starting to replace the air filterChecking the fuel pump’s air filter Check the level of the battery acid Dry-charged batteryIgnition system Replacing the spark plugCheck the safety system Main fuse Replacing the light bulbsChecking the tyre pressure When the engine is running. Mind your fingersChecking the engine’s cooling air intake Fitting the cutting headTrapping your hand Removing the cutting unitReplacing the cutting unit belts Adjusting the parallelism of the cutting unitChecking the cutting unit’s parallelism Placing in the service position Service position for the cutting unitRemoving the BioClip plug Restoring from service positionChecking the blades Checking the engine’s oil level LubricationChanging the oil filter Replacing the engine oilGeneral lubrication Lubricating the belt adjusterChecking the transmission oil level Problem Procedure Troubleshooting scheduleStorage ServiceWinter storage GuardTechnical data EC-declaration of conformity Applies to Europe only Page ´z+S!r¶6H¨ Page 1151018-26 ´z+S!r¶6H¨ ´z+S!r¶6H¨