Husqvarna 15V2s AWD manual Replacing the light bulbs, Main fuse

Page 25

Maintenance

Replacing the light bulbs

For information about the bulb type, see Technical Data.

1Loosen the lock nut and remove the Allen bolt. Remove the steering wheel.

2Unscrew the two screws holding the cover on the power servo housing. One screw on each side.

3Press in the parking lock button and lift the cover over the steering column.

4Carefully remove the lamp insert from its two brackets.

5Disconnect the cables from the bulbs.

6Lift out the bulbs from the insert.

7Insert the new bulbs. Make sure you use your thumb to support the front.

8Reﬁt the cables, lamp insert and the cover on the power servo housing.

9Replace the steering wheel.

Main fuse

The main fuse is placed in a detachable holder under the battery case’s cover, in front of the battery.

Type: Flat pin, 15 A.

Do not use any other type of fuse when replacing.

A blown fuse is indicated by a burnt connector. Pull the fuse from the holder when replacing.

The fuse is there to protect the electrical system. If it blows again shortly after replacement, it is due to a short circuit, which must be ﬁxed before the machine can be put into operation again.

English – 25

Image 25

Contents English Rider 15V2 Rider 15V2 AWD Rider 15V2s AWDContents Pre-delivery service Service journalAfter the ﬁrst 8 hours Dear Customer IntroductionDriving and transport on public roads TowingSerial Number Good serviceSymbols KEY to SymbolsBrake Starting instructions Safety instructions Safety InstructionsInsure your Rider General useThis is what you do Driving on slopesChildren MaintenanceTransport Location of the controls What is WHAT?Presentation Cutting unit Cutting height adjustment leverLifting lever for the cutting unit LightsFuelling Exercise care and refuel outdoors see safety instructionsRelease lever Release lever Rider 15V2 AWDBefore starting DrivingStart the engine Connecting the jump leads Starting the engine with a weak batteryDriving the Rider Remove the cables in the reverse orderStop the engine Cutting tipsOther objects which can be thrown out by the blades Maintenance schedule MaintenanceChecking and adjusting the steering wires CleaningRemoving of the machine hoods Adjusting the parking brake Rider 15V2 AWD Adjusting the parking brake RiderChecking and adjusting of throttle wire Can result in reduced braking abilityReplacement of fuel ﬁlter Checking and adjusting the choke wireReplacing the air ﬁlter Cool before starting to replace the air ﬁlterChecking the fuel pump’s air ﬁlter Check the level of the battery acid Dry-charged batteryIgnition system Replacing the spark plugCheck the safety system Main fuse Replacing the light bulbsChecking the tyre pressure When the engine is running. Mind your ﬁngersChecking the engine’s cooling air intake Fitting the cutting headTrapping your hand Removing the cutting unitChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitReplacing the cutting unit belts Placing in the service position Service position for the cutting unitChecking the blades Restoring from service positionRemoving the BioClip plug Checking the engine’s oil level LubricationChanging the oil ﬁlter Replacing the engine oilChecking the transmission oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Troubleshooting scheduleStorage ServiceWinter storage GuardTechnical data EC-declaration of conformity Applies to Europe only Page ´z+S!r¶6H¨ Page 1151018-26 ´z+S!r¶6H¨ ´z+S!r¶6H¨